Rock Splitter & Core Drill
Powerking Products
ROCK SPLITTER & CORE DRILL
Rock splitter
Non Vibration Rock Breaking Method by Powerking Rock splitter uses the multiple hydraulic pistons push the rock toward the free face side.
Work process
Drill the hole of which diameter is bigger than 80mmØ and 1~3 meter deep by crawler drill or leg drill.
Put the power cylinders into the holes and then push the rock toward the free face side.
Totally 1,000~ 1,400 ton power pushes the rock for 2-4 minute and then the rock will be split.
Application
On sites where there is a restriction or ban on the use of hydraulic impact hammers or conventional blasting methods.
In downtown core areas where there are by laws regarding noise and dust pollution.
Job sites near to electrical supplies, gas mains, water mains, or other services that can be adversely affected by vibration and fly rock.
Under, in, or beside historic buildings, that can be damaged by less controlled methods.
Excavating narrow trenches in rock, or concrete, dedicated to service lines such as gas, electricity, water and sewage.
Characteristics
Vibration free, noise free
Convenient Operation
High Efficiency
Low cost of rock breaking and maintenance
Versatile usage
CATALOG
POWERKING - ROCK SPLITTER(KOREA)
POWERKING - ROCK SPLITTER
Core Drill
- For drilling rock or concrete, a crawler drill (Top Hammering Drill) is generally used due to the good performance and convenience. However, this kind of drilling machine makes a lot of noise and dust.
The Excavator attached hydraulic driven diamond core drill, developed by Powerking, is a new concept machine for solving these problems.
Work process
- Install the Core Drill and connect the Hydraulic Hose line.
- Positioning of Core Drill and cleaning any loose soil.
- Water Supply.
- Open the Hydraulic Hose Line.
- Raising and Lowering of Core Bit
- Get out the remaining material
- Insert the Power Cylinder of Rock Splitter
- Secondary breaking
Application
- Drilling work of big Boulder
- Drilling work in crowd village
- Subway construction
- Road construction
- Trench work
Characteristics
- Very low drilling sound and no vibration.
- Power comes from Excavator. So, Crawler drill is not required
- Cylinder driven for shortening the height of equipment and deeper drilling.
CATALOG
POWERKING - Hyd Core-drill(KOREA)
CORE DRILL